Museum putty clear1/19/2024 ![]() Is product photography your bread and butter? Museum Wax will keep that squirrelly mascara applicator standing on end ready for its close-up, and just think of the stop motion animation potential.Having trouble getting that nonmagnetic screw into its hole? Stick a bead of Museum Wax on the tip of your screwdriver and insert that screw with one-handed surgical precision.Crooked picture frames? Museum Wax won’t hold up frames by itself, but add a small bead behind each lower corner of a frame in addition to the existing hanging hardware and your world won’t go so cockeyed.The manufacturer also warns against waxing particularly tall or top-heavy objects. ![]() Heat makes wax go soft, so keep that in mind if your shelf is above a stove or heater. The warm lights in the display case didn’t help. I had to return twice in the three-month run of the installation to correct the slow downhill ooze of that silverware. In my career at the museum I took a chance on waxing a setting of Art Deco silverware on a 2˚ slope inside a display case. But don’t try mounting objects on a slope. Indeed, this property helps make Museum Wax reversible. In most cases the wax will clean nicely off finished wood with a buffing cloth, but use caution when planting an Arts & Crafts vase on your Stickley table.įor best results, stick with objects with a flat base and stick ‘em on flat surfaces. Think about the finish on your shelf or table, too. Keep in mind what you will have to do to get the wax off when deciding if that matryoshka needs to be goobered in place. If any wax remains on the surface it can be cleaned with mineral spirits. In most cases, a wood popsicle-stick or plastic spatula (or perhaps even a spudger?) will be adequate to remove the wax from the base of an object. If your object has a porous surface like unfinished wood, bone, ivory, unglazed ceramic, or stone, the wax may become a permanent part of the surface.Paint can peel off and that gummy plasticizer seeping out of Barbie may do strange things with the wax. If your object is plastic or is painted, beware that anything oil-based (like wax) may react unpredictably with aging plastic polymers.Always remove objects with a slow steady twisting motion to release the wax, or slice the wax with dental floss or monofilament fishing line. A little wax goes a long way, so use small quantities first before coating the whole base of that purple unicorn with a 1/4 inch slab of wax. The hold of the wax may be stronger than the object itself. If your object is delicate or has a thin stem like a wine glass, beware when you remove the object from its waxed spot.It’s good for glass, plastic, wood, bone, stone, papier-mâché, and metal… with a caveat or three: Some three dimensional artwork required elaborate brackets and mounts fabricated from steel or brass and padded out with soft felt to safely manage their mass or delicacy, but usually we just followed a stick-it-to-the-deck-so-it-don’t-move-no-where plan.Īnd Museum Wax isn’t just for ceramics. ![]() Art conservation staff call it “seismic mitigation,” but we lowly preparators know this means, “Make sure it doesn’t fall over before the building collapses.” We had a plan: artwork was hung from at least two hooks anchored in a stud or plywood sheet, and the lower edge of every frame was locked down with special security hardware. In the decade I worked as a preparator installing artwork in California museums and art galleries, Museum Wax was my best ally in the fight against roaming temblors. ![]() The key? It’s “reversible,” a favorite adjective of art conservators everywhere. Museum Wax provides a firm hold for large urns and small cups and is still reasonably removable. And that’s not all-Museum Wax will tackle those finicky nonmagnetic screws and crooked pictures on the wall too.įor collectibles and artwork, Museum Wax beats duct tape, cyanoacrylate glue, bailing wire, and chewing gum hands down. Museum Wax is made of non-toxic, non-acidic, microcrystalline sticky stuff that can anchor your model Millenium Falcon or ground your grandfather’s carved Mallard drake. He has installed art everywhere from college art galleries to commercial galleries-even his own installations.Įvery collector of kitsch, fine china, or fossils has wondered, “How do I make my cookie jars stay put so they don’t clock me in the head when the train rumbles by?” If earthquakes, passing freight trains, and bumps in the night are causing havoc with your collectibles, Museum Wax can help you get a grip. Jeff Stephens is an inventory specialist at iFixit, and he worked for six years as a supervisor of installations at the Los Angeles County Museum of Art.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |